Questions in Taege RC300 Controller
Taege RC300 Electronic Rate Controller
- Controller wont turn on and the motor/s start when the power button is pressed.
(16427 views) - How do I find the software version?
(16249 views) - Controller beeps and shows "TOO FAST" and motor is spinning when the drill is stopped and in the "run" mode
(18973 views) - Hopper motor starts and stops when drilling
(16968 views) - How do I test that a motor is functioning?
(16212 views) - Area sown is smaller/greater than the known area sown.
(18266 views) - Wrong speed showing on the controller.(computer)
(20629 views) - Kph unstable on computer
(19129 views) - Hopper turns on immediately the power from the tractor is connected.
(17211 views) - Controller turns off when tractor is started or beeps.
(18962 views) - Controller turns off when operator is not on the tractor seat
(18381 views) - Controller will not turn on.
(18824 views) - Factory settings for Rc300 controllers
(15935 views) - prime button doesn't work on RC300 verion 2.52d
(15996 views) - How do I find the “Power Status Screen”?
(16212 views) - No Kph moving on the screen of the controller when in the “RUN” mode and moving
(18584 views) - Controller beeps when tractor started.
(18166 views) - Can I arc weld while the drill is attached and the power is connected to the tractor.
(18704 views)
Taege RC300 Electronic Rate Controller